- one ceramic pendant with hole
- approximately 8 inches of 20 gauge wire
Start by sliding the wire half way through the hole of the pendant.
With one end of the wire, wrap it around the pendant When doing so, try to conceal the hole.
Bring the second end of the wire to the top of the pendant. 
Make a small wire loop, do not trim the excess wire.
Finish the pendant by wrapping the remaining wire around the pendant.
If you have sharp edges on your wire, you can turn the ends into the pendant.
Post written by Jennifer Heynen a.k.a. Jennifer Jangles
Barbara Forbes-Lyons
March 29, 2011 at 8:27 pmAnother way to smooth the sharp ends of wire is by using a cup-burr.
For example:
http://www.cooltools.us/Cup-Bur-Wire-Rounding-1-8mm-p/drl-351.htm
CraftCrave
March 30, 2011 at 1:10 amJust a quick note to let you know that a link to this post will be placed on CraftCrave today [30 Mar 01:00am GMT]. Thanks, Maria